产品材料以及材料的热处理温度及处理后的材料硬度、表面处理、放气性材料或放气性结构都必须准确标识在产品信息表单内。其它针对与材料相关的特殊处理请务必提前与技术人员沟通。

Product materials and materials after the heat treatment  temperature and treatment of material hard degree,surface treatment, put gas or gas structure must be accurately identified in the product information in the form. Other associated with material for special processing please communicate with technical  staff  inadvance.

产品因设计， 装配以及外观等需要对于涂层为止合理遮蔽请在标准图纸或示意图中标识， 此类信息需流转至工艺各流程。

Products for design,assembly,and appearance and so on need to coating position reasonable cover pleases identify in the standard drawings or sketches, such information should flow to the process of each process.

产品需要拆解至最小单元，否则会因装配污染造成脱膜。

Products need to disassemble to the smallest  unit,otherwise it will caused by assembly pollution to take off  the membrane.

深孔及狭缝内涂层不能达到， 需要确认有效深度。

Deep hole and slot coating cannot reach,need to confirm the effective depth.